
Related
Commands class-map — identifies the class map.
match ip vlanUses a VLAN as the match criterion for an L3 class map.
Z9500
Syntax match ip vlan vlan-id
To remove VLAN as the match criterion, use the no match ip vlan vlan-id
command.
Parameters vlan vlan-id Enter the keyword vlan and then the ID of the VLAN. The
range is from 1 to 4094.
Defaults none
Command
Modes
CONF-CLASS-MAP
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VLAN ID .
Related
Commands
class-map — identifies the class map.
match mac access-groupConfigure a match criterion for a class map, based on the contents of the designated MAC ACL.
Z9500
Syntax match mac access-group {mac-acl-name}
Parameters mac-acl-name Enter a MAC ACL name. Its contents is used as the match
criteria in the class map.
Quality of Service (QoS) 1495