Dell 9.8(0.0) PIM-Sparse Mode (PIM-SM)

37
PIM-Sparse Mode (PIM-SM)
The protocol-independent multicast (PIM) commands are supported by the Dell Networking operating
software on the platform.
IPv4 PIM-Sparse Mode Commands
The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.
clear ip pim rp-mapping
The bootstrap router (BSR) feature uses this command to remove all or particular rendezvous point (RP)
advertisement.
Z9500
Syntax clear ip pim [vrf vrf-name] rp-mapping [rp-address]
Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
rp-address (OPTIONAL) Enter the RP address in dotted decimal format
(A.B.C.D).
Command
Modes
EXEC Privilege
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
PIM-Sparse Mode (PIM-SM) 1373