Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage
Information This command turns on BGP soft-reconfiguration inbound debugging. If no
neighbor is specified, debug turns on for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
Z9500
Syntax debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] updates [in | out | prefix-list prefix-list-
name]
To disable debugging, use the no debug ip bgp [A.B.C.D | X:X:X:X::X |
peer-group peer-group-name] updates [in | out | prefix-list
prefix-list-name] command.
Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to view BGP updates information corresponding to
that VRF.
A.B.C.D (OPTIONAL) Enter an IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group
peer-group-
name
(OPTIONAL) Enter the keyword peer-group followed by the
name of the peer group.
in (OPTIONAL) Enter the keyword in to view only BGP updates
received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP
updates sent to neighbors.
prefix-list
prefix-list-
name
(OPTIONAL) Enter the keyword prefix-list then the
name of an established prefix list. If the prefix list is not
configured, the default is permit (to allow all routes).
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
Border Gateway Protocol 401