1/5(Up) Te 1/6(Up)
Uplink State Group : 5 Status: Enabled, Down
Upstream Interfaces : Te 0/0(Dwn) Te 0/3(Dwn) Te 0/5(Dwn)
Downstream Interfaces : Te 1/2(Dis) Te 1/4(Dis) Te 1/11(Dis)
Te 1/12(Dis) Te 1/13(Dis) Te 1/14(Dis) Te 1/15(Dis)
Uplink State Group : 6 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 7 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 16 Status: Disabled, Up
Upstream Interfaces : Te 0/41(Dwn) Po 8(Dwn)
Downstream Interfaces : Te 0/40(Dwn)
Related
Commands •show running-config uplink-state-group — displays the current configuration
of one or more uplink-state groups.
•uplink-state-group — create an uplink-state group and enables the tracking of
upstream links.
uplink-state-group
Create an uplink-state group and enable the tracking of upstream links on a switch/ router.
Z9500
Syntax uplink-state-group group-id
To delete an uplink-state group, enter the no uplink-state-group group-id
command.
Parameters group-id Enter the ID number of an uplink-state group. The range is
from 1 to 16.
Defaults none
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1822 Uplink Failure Detection (UFD)