neighbor send-community — sends COMMUNITY attribute to peer or peer group.
match interface
To match routes whose next hop is on the interface specified, configure a filter.
Z9500
Syntax match interface interface
To remove a match, use the no match interface interface command.
Parameters interface Enter the following keywords and slot/port or number
information:
• .
• For the loopback interface, enter the keyword loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094 (you can use IDs 1 to 4094).
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
Access Control Lists (ACL) 309