ip access-group
Assign an IP access list (IP ACL) to an interface.
Z9500
Syntax ip access-group access-list-name {in | out} [implicit-permit]
[vlan vlan-id]
To delete an IP access-group configuration, use the no ip access-group
access-list-name {in | out} [implicit-permit] [vlan vlan-id]
command.
Parameters access-list-
name
Enter the name of a configured access list, up to 140
characters.
in Enter the keyword in to apply the ACL to incoming traffic.
out Enter the keyword out to apply the ACL to outgoing traffic.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to
change the default action of the ACL from implicit-deny to
implicit-permit (that is, if the traffic does not match the filters
in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of
the VLANs. The range is from 1 to 4094 (you can use IDs
from 1 to 4094).
Defaults Not enabled.
Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
218 Access Control Lists (ACL)