cam-acl (Configuration)
Select the default CAM allocation settings or reconfigure a new CAM allocation for Layer 2, IPv4, and IPv6
ACLs, Layer 2 and Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address
validation for DHCP, Ethernet Connectivity Fault Management (CFM) ACLs, OpenFlow, and Policy-based
Routing (PBR).
Z9500
Syntax cam-acl {default | l2acl number ipv4acl number ipv6acl number
ipv4qos number l2qos number l2pt number ipmacacl number ecfmacl
number [nlbclusteraclnumber][vman-qos | vman-dual-qos number]
ipv4pbr number}openflow {4|8} | fcoe number}
Parameters default Use the default CAM profile settings and set the CAM as
follows:
• L3 ACL (ipv4acl): 4
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
• nlbclusteracl: 2
• OpenFlow: 0 (disabled)
l2acl number
ipv4acl number
ipv6acl
number,
ipv4qos
number l2qos
numberl2pt
number
ipmacacl
number
ecfmacl
number
[nlbclusteracl
number]
[vman-qos |
vman-dual-qos
number]
ipv4pbr
numberopenflo
w {4|8} | fcoe
number
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space
to be allotted. The total space allocated must equal 13. The
range for ipv4acl is from 1 to 4. The ipv6acl range must be a
factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller
(256 total entries minus the 14 entries reserved for
internal functionality)
• 8: Creates 498 entries for use by the OpenFlow controller
(512 total entries minus the 14 entries reserved for
internal functionality)
The fcoe range is 0–6 groups. Each group has 128 entries;
the value given must be an even number. This information is
stored in the NVRAM and is effective after rebooting the
switch.
580 Content Addressable Memory (CAM)