Version Description
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip pim neighbor command shown in the
following example.
Field Description
Neighbor address Displays the IP address of the PIM neighbor.
Interface List the interface type, with either slot/port information or ID
(VLAN or Port Channel), on which the PIM neighbor was
found.
Uptime/expires Displays the amount of time the neighbor has been up then
the amount of time until the neighbor is removed from the
multicast routing table (that is, until the neighbor hold time
expires).
Ver Displays the PIM version number.
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode.
• 1 = default Designated Router priority (use the ip pim
dr-priority command)
• DR = Designated Router
• S = Sparse mode
Example Dell#show ip pim neighbor
Neighbor Interface Uptime/Expires Ver DR
Address Prio/Mode
127.87.3.4 Te 1/16 09:44:58/00:01:24 v2 1 / S
Dell#
show ip pim rp
View all multicast groups-to-RP mappings.
Z9500
Syntax show ip pim [vrf vrf-name] rp [mapping | group-address]
Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
PIM-Sparse Mode (PIM-SM) 1393