Parameters {all | auto-
detect-timer |
config-exchng
| fail | mgmt |
resource | sem
| tlv}
Enter the type of debugging, where:
•all: enables all DCBX debugging operations.
•auto-detect-timer: enables traces for DCBX auto-
detect timers.
•config-exchng: enables traces for DCBX configuration
exchanges.
•fail: enables traces for DCBX failures.
•mgmt: enables traces for DCBX management frames.
•resource: enables traces for DCBX system resource
frames.
•sem: enables traces for the DCBX state machine.
•tlv: enables traces for DCBX TLVs.
Defaults none
Command
Modes
EXEC Privilege
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the Z9500.
fcoe priority-bits
Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
Syntax fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits
command.
Parameters priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x8
Command
Modes
PROTOCOL LLDP
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
620 Data Center Bridging (DCB)