To disable sending a COMMUNITY attribute, use the no neighbor {ipv6-
address | peer-group-name} send-community command.
Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group to send a COMMUNITY
attribute to all routers within the peer group.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
neighbor soft-reconfiguration inbound
Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
Z9500
Syntax neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters ipv4-address |
ipv6-address
Enter the IP address of the neighbor for which you want to
start storing inbound routing updates.
peer-group-
name
Enter the name of the peer group for which you want to start
storing inbound routing updates.
Defaults Disabled.
Command
Modes
ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
552 Border Gateway Protocol