Dell 9.8(0.0) show config (from INTERFACE RANGE mode)

Version Description
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
Example Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/7
no ip address
switchport
no shutdown
Dell(conf-if)#
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (interface range).
Z9500
Syntax show config
Command
Modes
CONFIGURATION INTERFACE (conf-if-range)
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example Dell(conf)#interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-1/1-2)#show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
Interfaces 865