vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Z9500
Syntax vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
Usage
Information Prior to enabling this command, to place the interface in Layer 2 mode, enter the
switchport command.
To remove the access port designation, remove the port (using the no member
interface command) from all stackable VLAN enabled VLANs.
vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
Z9500
Syntax vlan-stack compatible
1828 VLAN Stacking