neighbor
Define a neighbor router with which to exchange RIP information.
Z9500
Syntax neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters ip-address Enter the IP address, in dotted decimal format, of a router
with which to exchange information.
Defaults Not configured.
Command
Modes
ROUTER RIP
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information When a neighbor router is identified, unicast data exchanges occur. Multiple
neighbor routers are possible.
To ensure that only specific interfaces are receiving and sending data, use the
passive-interface command with the neighbor command.
Related
Commands
passive-interface — sets the interface to only listen to RIP broadcasts.
1546 Routing Information Protocol (RIP)