Dell 9.8(0.0) duplex (Management)

Defaults none

Command

Modes

INTERFACE

Command

History This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

7.4.1.0 Modified for E-Series: Revised from 78 to 240 characters.

Usage

Information Important Points to Remember:

• To use special characters as a part of the description string, you must enclose

the whole string in double quotes.

• Spaces between characters are not preserved after entering this command

unless you enclose the entire description in quotation marks (“desc_text”).

• Entering a text string after the description command overwrites any previous

text string that you previously configured as the description.

• The shutdown and description commands are the only commands that you

can configure on an interface that is a member of a port-channel.

• Use the show interfaces description command to display descriptions

configured for each interface.

Commands

show interfaces — displays information about an interface.

duplex (Management)

Set the mode of the Management interface.

Z9500

Syntax duplex {half | full}

To return to the default setting, use the no duplex command.

838 Interfaces