ip multicast-routing
Enable IP multicast forwarding.
Z9500
Syntax ip multicast-routing [vrf vrf-name]
To disable multicast forwarding, use the no ip multicast-routing [vrf
vrf-name] command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
E-Series legacy
command
Usage
Information After you enable multicast, you can enable IGMP and PIM on an interface. In
INTERFACE mode, enter the ip pim sparse-mode command to enable IGMP
and PIM on the interface.
Related
Commands
ip pim sparse-mode — enables IGMP and PIM on an interface.
show ip mroute
View the multicast routing table.
Syntax show ip mroute [vrf vrf-name] [static | group-address [source-
address] | count | snooping [vlan vlan-idIntroduced on the
S6000-ON.] [group-address [source-address]] | summary | vlt
[group-address [source-address] | count]
Multicast 1209