ip igmp access-group
To specify access control for packets, use this feature.
Z9500
Syntax ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list
command.
Parameters access-list Enter the name of the extended ACL (16 characters
maximum).
Defaults Not configured
Command
Modes
INTERFACE (conf-if-interface-slot/port)
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced on the E-Series.
Usage
Information
The access list accepted is an extended ACL. To block IGMP reports from hosts, on
a per-interface basis based on the group address and source address that you
specify in the access list, use this feature.
ip igmp group-join-limit
To limit the number of IGMP groups that can be joined in a second, use this feature.
Z9500
Syntax ip igmp group-join-limit number
Parameters number Enter the number of IGMP groups permitted to join in a
second. The range is from 1 to 10000.
808 Internet Group Management Protocol (IGMP)