Version 9.3.0.0 Introduced on the S6000 platform.
Usage
Information With the introduction of various overlay technologies such as network virtualization
using generic routing encapsulation (NVGRE) segments and Routable Remote
Direct Memory Access (RRDMA) over Converged Ethernet (RRoCE), information
related to a traffic flow is contained in the L4 header. The fields in the L2 and L3
headers are not sufficient to distinguish the flows. Therefore, the fields in the L4
header are processed when hashing is performed on packets over LAG and ECMP
links. The Flex hash functionality enables you to configure a packet search key and
matches packets based on the search key. When a packet matches the search key,
two 16-bit hash fields are extracted from the start of the L4 header and provided as
inputs (bins 2 and 3) for RTAG7 hash computation. You must specify the offset of
hash fields from the start of the L4 header, which contains a flow identification
field.
You can cause the system to include the fields present at the offsets that you
define (from the start of the L4 header) as a part of LAG and ECMP computation.
Also, you can specify whether the IPv4 or IPv6 packets are processed with the Flex
hash functionality.
Example Dell(conf)# load-balance flexhash ipv4 ip-proto 1 desc offset1
1 offset2 2
lacp fast-switchover
Cause the physical ports to be aggregated faster by configuring this capability in a port-channel on both
the nodes that are members of a port-channel.
C9000 Series
Syntax lacp fast-switchover
To disable the capability of faster aggregation of the member ports of a LAG or a
port-channel bundle, use the no version of this command.
Defaults Not configured
Command
Modes
INTERFACE (conf-if-po-number)
Command
History Version Description
9.x.x.x Introduced on the C9000.
9.3(0.0) Introduced on the S6000.
754 Flex Hash