Dell 9.8(0.0) ETS Commands

ETS Commands

Enable data center bridging.

Syntax dcb enable[pfc-queues 1|4]

To disable DCB, use the no dcb enable command.

Parameters pfc-queues Enter the pfc-queue range. To disable DCB, use the no dcb

enable command. The range is from 1 to 4.

Defaults The default is 2

Command

Modes

CONFIGURATION

Command

History This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the Z9500.

Usage

Information By default, iSCSI is enabled on the unit and the flow control is enabled on all of the

interfaces. It is also acts as defaults when the link-level flow control is enabled on

one or more interfaces. To enable DCB, do one of the following:

• Apply the dcb-map command with the no pfc-mode command on to all the

interfaces.

• Disable flow-control on all of the interfaces.

Clear all ETS TLV counters on an interface.

Syntax clear ets counters port-type slot/port

Parameters port-type Enter the keywords port-type then the slot/port

information.

Defaults none

Command

Modes

EXEC Privilege

614 Data Center Bridging (DCB)