Version Description
6.1.1.0 Introduced on the E-Series.
Usage
Information You can configure multiple time-serving hosts (up to 250). From these time-
serving hosts, the system chooses one NTP host with which to synchronize. To
determine which server was selected, use the show ntp associations
command.
Because many polls to NTP hosts can impact network performance, Dell
Networking recommends limiting the number of hosts configured.
Related
Commands
show ntp associations — displays the NTP servers configured and their status.
ntp source
Specify an interface’s IP address to be included in the NTP packets.
Z9500
Syntax ntp source interface
To delete the configuration, use the no ntp source command.
Parameters interface Enter the following keywords and slot/port or number
information:
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword lag then
a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
1796 System Time and Date