fefd reset
Reset all interfaces or a single interface that was in “error-disabled” mode.
Z9500
Syntax fefd reset [interface]
Parameters interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Defaults Not configured.
Command
Modes
EXEC Privilege
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
Related
Commands •fefd — enables far-end failure detection.
fefd-global interval
Configure an interval between FEFD control packets.
Z9500
Syntax fefd-global interval seconds
To return to the default value, use the no fefd-global interval command.
Layer 2 1169