To delete a filter, use the no seq sequence-number command.
Parameters sequence-
number
Enter a number from 1 to 65535.
permit Enter the keyword permit assign the sequence to the
permit list.
redirect Enter the keyword redirect to assign the sequence to the
redirect list.
ip-address Enter the IP address of the forwarding router.
ip-protocol-
number
Enter the keyword ip-protocol-number then the number
from 0 to 255 for the protocol identified in the IP protocol
header.
tunnel Enter the keyword tunnel to configure the tunnel setting.
tunnel-id Enter the keyword tunnel-idto redirect the traffic.
track Enter the keyword track to enable the tracking.
track <obj-id> Enter the keyword track <obj-id> to track object-id.
protocol-type Enter one of the following keywords as the protocol type:
•icmp for internet control message protocol
•ip for any internet protocol
•tcp for transmission control protocol
•udp for user datagram protocol
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to
the filter.
host ip-address Enter the keyword host then the IP address to specify a host
IP address.
destination Enter the IP address of the network or host to which the
packets are sent.
bit (OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
•ack = acknowledgement
•fin = finish (no more data from the user)
•psh = push function
•rst = reset the connection
•syn = synchronize sequence number
•urg = urgent field
1430 Policy-based Routing (PBR)