permit — configures a filter to forward packets.
IP Prefix List Commands
When you create an access-list without any rule and then apply it to an interface, the ACL behavior
reflects implicit permit.
To configure or enable IP prefix lists, use these commands.

access-class

Apply a standard ACL to a terminal line.
Syntax access-class access-list-name [ipv4 | ipv6]
To remove an ACL, use the no access-class access-list-name [ipv4 |
ipv6] command.
Parameters access-list-
name
Enter the name of a configured Standard ACL, up to 140
characters.
ipv4 Enter the keyword ipv4 to configure an IPv4 access class.
ipv6 Enter the keyword ipv6 to configure an IPv6 access class.
Defaults Not configured.
Command
Modes
LINE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Added the ipv4 and ipv6 parameters to the command.
Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
Access Control Lists (ACL) 295