timers bgp

Allows you to adjust the BGP network timers for all neighbors.
Z9500
Syntax timers bgp keepalive holdtimer
To return to the default values, use the no timers bgp command.
Parameters keepalive Enter the time interval in seconds between which the
software sends keepalive messages. The range is 1 to 65535.
The default is 60 seconds.
holdtimer Enter the time interval in seconds which the software waits
since the last keepalive message before declaring a BGP peer
dead. The range is 3 to 65535. The default is 180 seconds.
Defaults •keepalive = 60 seconds
•holdtimer = 180 seconds
Command
Modes
ROUTER BGP
Command
History Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Related
Commands
neighbor timers – adjusts BGP timers for a specific peer or peer group.
IPv6 MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables the multicast routing policy throughout the
internet and connecting multicast topologies between BGP and autonomous systems (AS). MBGP is
implemented as per IETF RFC 1858.
Border Gateway Protocol 577