Avaya 555-231-743 manual User’s Guide

GuestWorks and DEFINITY ECS Release 9	Issue 1
Technician Handbook for Hospitality Installations 555-231-743	November 2000
Installing the System
Connecting the Hospitality Adjuncts	58

7400B Options

The options on the 7400B must be set using an ASCII data terminal or a PC using a terminal emulation package. You must connect the data terminal or PC to the EIA interface connector on the back of the 7400B. For the switch-to-PMS link, only a subset of options must be changed. These options are changed using the AT command set. Use the following steps to set the options on the 7400B:

1.Set the option dip switches SW1-1 to ON (without phone), SW1-5 to OFF, and SW1-8 to OFF.

2.Set the speed on the data terminal or terminal emulation package to match the speed of the PMS. By doing this, the speed on the 7400B will autobaud to match the correct speed.

3. From the data terminal or PC, type at Enter . This automatically sets the speed and parity for the connection. The OK prompt should display.

4.Type the following commands as shown. (The character 0 is the number

	zero.) Before you press						Enter for each command, make sure that the
	command has been entered correctly. The e0 option on the last command
	turns off keyboard echo, which means that after you enter this command,
	any future keyboard entries will not be displayed, and the OK prompt is not
	displayed.
	at&f		Enter (the	OK prompt displays)
	at&c1&d2&s1s0=1				Enter		(the	OK prompt displays)
	ate0q1&w0&y0&v				Enter
	The &v portion of the last command displays the current set of options.
	Your screen should look something like this:
ACTIVE PROFILE:
B1 E0 L2 M1 Q1 V1			X4 Y0 &C1 &D2 &G0 &J0 &L0 &P0 &Q0 &R0 &S1 &X0 &Y0
S00:001	S01:000	S02:043 S03:013		S04:010		S05:008		S06:002	S07:060
S08:002 S09:006 S10:014 S12:050 S14:AAH S16:00H S18:000 S21:00H
S22:76H S23:0BH S25:005 S26:001 S27:40H
STORED PROFILE 0:
B1 E0 L2 M1 Q1 V1			X1 Y0 &C1 &D2 &G0 &J0 &L0 &P0 &Q0 &R0 &S1 &X0
S00:001 S14:AAH S18:000 S21:00H S22:76H S23:0BH S25:005 S26:001
S27:40H
STORED PROFILE 1:
B1 E1 L2 M1 Q0 V1			X4 Y0 &C0 &D0 &G0 &J0 &L0 &P0 &Q0 &R0 &S0 &X0

S00:000 S14:AAH S18:000 S21:00H S22:76H S23:1BH S25:005 S26:001

S27:40H

TELEPHONE NUMBERS:

5.Disconnect the data terminal or PC from the 7400B.

6.Reconnect the unit as shown in Figure 18.

If your PMS requires a different set of options, consult the 7400B Data Module

User’s Guide.