GuestWorks and DEFINITY ECS Release 9
Technician Handbook for Hospitality Installations
555-231-743 Issue 1
November 2000
Translations and Testing
160Switch-to-INTUITY Translations
Assign IP Interfaces
Use the change ip-interfaces command to administer a C-LAN circuit pack as an
IP interface.
■Enable Eth Pt — Enter y to enable the C-LAN IP interface. After initial
administration, you must disable the interface before you make any
changes.
■Type — Enter C-LAN.
■Slot — Enter the equipment location of the C-LAN circuit pack.
■Code/Sfx — This is a display-only field that shows the designation
number of the circuit pack installed in the specified slot.
■Node Name — Enter the switch node name assigned on Page 2 of the
Node Names screen. In this example, enter guestworks. The same node
name cannot be assigned to two different IP interfaces.
■Subnet Mask — Identifies which portion of an IP address is a network
address and which is a host identifier. Use the default entry
of 255.255.255.0, or check with the LAN administrator on site if co nnecting
through the customer’s LAN.
■Gateway Address — Enter the address of a network node that will serve
as the default gateway for the IP interface. If the application goes to points
off the subnet, a gateway address of the router is required. If th e switch and
the INTUITY are on the same subnet, a gateway address is not required. If
using ethernet only, and a gateway address is administered, no IP routes
are required.
■Network Region — For a C-LAN IP interface, enter 1.
change ip-interfaces Page 1 of 4
IP INTERFACES
Enable Net
Eth Pt Type Slot Code Sfx Node Name Subnet Mask Gateway Address Rgn
y C-LAN 01A02 TN799 C guestworks 255.255.255.0 192.168.1 .255 1
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .
n 255.255.255.0 . . .