Action | Key Sequence | Comments |
|
|
|
POWER OFF | CTRL P 0 | CTRL P is the prefix for the Power |
|
| commands. The 0 indicates an OFF |
|
| selection. |
|
|
|
ACPI PRESS | CTRL P 6 | CTRL P is the prefix for the Power |
|
| commands. The 6 indicates an ACPI |
|
| power press. The ACPI power press is |
|
| equivalent to holding the power button for |
|
| approximately 6 seconds. |
|
|
|
SYSTEM | CTRL P ! | CTRL P is the prefix for the Power |
REBOOT |
| commands. The ! indicates an immediate |
|
| emergency reboot. |
|
|
|
UID ON | CTRL U 1 | CTRL U is the prefix for the UID |
|
| commands. The 1 indicates an ON |
|
| selection |
UID OFF | CTRL U 0 | CTRL U is the prefix for the UID |
|
| commands. The 0 indicates an OFF |
|
| selection. |
|
|
|
Key sequences operate during a telnet Remote Console session or Virtual Serial Port session. The keys do not work before authentication. The power control requests are correctly ignored when you do not have the correct power control privileges.
Telnet SecurityTelnet is an unsecured network protocol. To reduce any security risks:
•Use SSH instead of telnet. SSH is essentially secure or encrypted telnet. CLI is supported through telnet as well as SSH.
•Use a segregated management network. Preventing unauthorized access to the network segment prevents unauthorized activity.
Supported Key SequencesiLO supports the VT100+ protocol. The following tables define the supported key sequences.