. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Updating Firmware in the DCS 465 Camera Back

The DCS 465 Camera Back incorporates nonvolatile memory that con- tains controls — called firmware — for most features of the camera back. You can update that firmware yourself, which means you can keep the camera back up-to-date as changes are made to the firmware. (Refer to the appendix “Updating Your Kodak Software Driver,” for additional information.) You can also perform some troubleshooting without sending the camera back to a service center, as described in the camera back troubleshooting section of this manual.

By following the steps below to update camera back firmware the first time you use the TWAIN driver, you will ensure that the camera back contains the most current version of the firmware. You do not need to update camera back firmware each time you use the driver.

NOTE: To complete these steps, the camera back must be connected to your PC as described earlier in this chapter. We also assume that one of the software applications described earlier in this chapter is currently running on your PC, and that you have accessed the driver image window, which is shown on the next page.

5-48  Preparing for Use with PC G

Page 148
Image 148
Kodak user manual Updating Firmware in the DCS 465 Camera Back