. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Message

Possible Cause

Suggested Solution

 

 

 

“Timeout during

A problem with the

For any of this group of

Command phase.”

hardware has been

messages, verify that all SCSI

“Timeout during Data

detected.

connections are correct (if

 

necessary turn off all equipment

phase.”

 

 

to alter the connections), make

“Timeout during Message

 

 

sure the camera back has a

phase.”

 

unique SCSI ID, and try again.

“Timeout during Selection

 

 

phase.”

 

 

“Timeout during Status

 

 

phase.”

 

 

“Timeout waiting for

 

 

initial bus free phase.”

 

 

 

 

 

“TWAIN DCSxxx source

A problem has occurred

For any of this group of

error. (Remaining wording

with the software driver.

messages, try the operation

of message varies).”

 

again. If necessary, reinstall the

 

 

TWAIN driver and try again. If

 

 

the problem continues, contact

 

 

Kodak.

“TWAIN DCSxxx source error. Low memory condition encountered. Free up some memory and try again.”

There is not enough memory to complete the operation.

Be certain that the computer meets the minimum system requirements (refer to chapter 1). Shut down other applications if they are running and try again.

“TWAIN Error. Error

A TWAIN-compliant

accessing data source.

KODAK Driver has not

Failure due to unknown

been installed or has

causes.”

been installed

 

improperly.

Reinstall the driver as described in chapter 5 and try again.

“TWAIN Error. Error

A TWAIN-compliant

opening Data Source.

KODAK Driver has not

Failure due to unknown

been installed or has

causes.”

been installed

 

improperly.

Reinstall the driver as described in chapter 5 and try again.

11-40  Reference — KODAK Drivers for TWAIN-Compliant PC Applications G

Page 346
Image 346
Kodak DCS 465 user manual Message Possible Cause Suggested Solution