. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Install the driver for Adobe Photoshop Software and the camera back calibration file (CAL) on your Macintosh computer.
Insert (and remove) your PCMCIA card into the DCS 465 Camera Back.
Access the driver for Adobe Photoshop Software.
Update camera back firmware.
Format a PCMCIA card for use with the camera back.
IMPORTANT: We assume that you are familiar with the operation of your Macintosh computer. If you are not, refer to the manuals that accompany that computer before continuing.
Before you continue, if you have not completed and returned the enclosed Warranty Registration card, please do so now.
CAUTION: In this chapter you will connect the camera back to your computer. Once connected, do not disconnect the camera back from the computer while using the supplied software, or even while the computer is on. Doing so may result in the loss of data from the PCMCIA card in the camera back or from the hard disk in your computer. Instead, turn off all equipment in the order described at the end of this chapter before disconnecting the camera back.
