
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Message | Possible Cause | Suggested Solution |
|
|
|
“The image file filename | The file is Read Only. |
cannot be deleted because |
|
it is |
|
To delete the file, you must first use the File Manager to turn off the Read Only property attribute for the file.
“The last SCSI command | A hardware error has |
completed with an error.” | been detected in the |
| cabling or SCSI |
| connectors. |
Verify that all SCSI connections are correct (if necessary turn off all equipment to alter the connections). Try other cables if available. Be certain that terminators (if used with your computer setup) are still properly connected. If the problem persists, contact Kodak.
“The matrix file filename | A problem occurred with |
is not compatible with the | the software driver, |
current TWAIN driver. | perhaps during |
Please reinstall the driver.” | installation. |
Reinstall the driver as described in chapter 5, and try again.
If the problem persists, obtain a new driver (refer to Appendix A), install it, and try again.
“The SCSI manager is busy and cannot handle the current request at this time.”
A problem occurred when the software driver tried to communicate with the camera back.
Try again; if the problem persists, contact Kodak.
“There are no image files in this folder. To select another folder, click the Change Folder button.”
The current folder, or a PCMCIA card in the computer drive, contains no images.
Select another folder or use a different PCMCIA card.
“There are no images in the camera.”
The PCMCIA card in the camera back contains no images, or no card is present.
Insert a PCMCIA card into the camera back if one in not present, or insert another PCMCIA card known to contain images, or use the camera back to take pictures without a card in place.