. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Message | Possible Cause | Suggested Solution |
|
|
|
“Cannot have same folder open for acquiring from and saving to.”
While working with an archive folder (the Source is Folder), you have selected images, chosen “Copy to Folder” or “Move to Folder,” and tried to save the images using the same filename as the opened archive file.
Try again, but this time create a new folder or use a folder other than the opened archive folder.
“Cannot locate the SCSI | The driver does not find |
host adapter.” | the SCSI host adapter. |
You must have a supported SCSI host adapter installed to access files from the camera back. (Refer to chapter 1.)
If necessary have a technician install this board, or perform troubleshooting on an already installed board.
“Cannot read filename.” | An unusual condition |
| was detected when trying |
| to read this file, for |
| example the file is in the |
| wrong format. |
Try again, and if unsuccessful and the file is known to be an image file, reinstall the driver. If problems persist you may be unable to access images from this folder.
“Cannot read filename, | An unusual condition |
Invalid file format.” | was detected when trying |
| to read this file, for |
| example the file is in the |
| wrong format. |
Try again and if unsuccessful reinstall the driver as described in chapter 5, then try again. If problems persist you may be unable to access images from this file.
“Cannot read PCMCIA | The software driver is |
disk in the camera.” | unable to read data from |
| the PCMCIA card; |
| perhaps the card was |
| removed from the |
| camera back just as the |
| driver attempted to read |
| it. |
Be certain that the PCMCIA card is firmly seated in the camera back and try again.
Reference — KODAK Drivers for
