. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8.(Optional) Later, to disconnect the camera back from the Macintosh computer, shut down the computer and all external SCSI devices. Then restore the SCSI cables and terminator to the state they were in before the camera back was connected. Do not leave a SCSI cable with an empty connector dangling from a SCSI chain.
Skip the next section and continue at “Installing the KODAK Driver for Adobe Photoshop Software (Macintosh) and the Calibration File” later in this chapter.
B.Follow these steps if the last connected device is terminated internally.
1.Turn off the Macintosh computer, and all connected SCSI devices.
IMPORTANT: Later when you connect and disconnect the Macintosh computer and the DCS 465 Camera Back on a regular basis, make sure that all devices are off. Some software and peripherals check the SCSI connection periodically. If the Macintosh computer is on, and you connect the camera back while the SCSI connection is being used, the Macintosh computer may hang and you will need to restart.
2.Place the DCS 465 Camera Back in a convenient position next to the last device in the SCSI chain of devices connected to your Macintosh computer.
3.Connect the AC battery charger/adapter to the camera back as de- scribed earlier in this chapter. Although this step is optional, we recommend it whenever the camera back is connected to a computer.