NaviBot S SR8980
VCR8980L3K/XEF, VCR8980L3K/XEG, VCR8980L3K/XEO, VCR8980L3K/XET
Charging, OPERATING, operating _23, robot manually, sound from the charger, -The Charging Lamp turns green, the main unit until you hear a Recharging power
When the product is initially purchased, the battery is fully
discharged, and you must charge the vacuum cleaning
Turn on the Power Switch at the bottom of the product.1.After aligning the charge pins of the main unit
with the charge pin of the charger station, press
the main unit until you hear a Recharging power
sound from the charger.
-The Charging Lamp turns green.
2.Check the charge status of the vacuum cleaning robot.-When charging starts, “the amount of remaining battery power”and “ ” are displayed on the status display panel in this sequence.
-When charging is complete, the battery level indicator and “FULL” will be displayed in the display panel.
■When the battery level display ﬂ ashes while cleaning, the vacuum cleaning robot stops vacuuming and automatically charges itself at the charger.
■If the vacuum cleaning robot starts the current cleaning run at a location other than the charging station and fails to locate the charging station while cleaning, it will stop near the location where it started cleaning.
■When the battery level ﬂ ashes and “Lo” is displayed while cleaning, vacuum cleaning robot cannot be operated by the remote control or the buttons on the main unit. In this case, directly carry the vacuum cleaning robot to the charger to charge the battery. (This is when the battery is completely discharged.)