3D Connexion Version 6.6

*MAP SOLUTION

13.1 *MAP SOLUTION: Map a solution from an old mesh to a new mesh.

Thisoption is used to transfer solution variables from an earlier analysis to a new mesh that occupies the same

space.

Product: ABAQUS/Standard

Type: Model data

Level: Model

Reference:

•“Mesh-to-mesh solution mapping,” Section 12.4.1of the ABAQUS A nalysisUser ’sManual

Optional parameters:

INC

Set this parameter equal to the increment number from which the old solutionwill be read. If this

parameter is omitted, the last increment for which a solution is availa ble will be read.

The STEP parameter must be speciﬁed if the INC parameter is used.

STEP

Set this parameter equal to the step number from which the old solution will be read. If this

parameter is omitted, the last step and increment for which a solutio nis a vailable will be read.

UNBALANCED STRESS

Set UNBALANCED STRESS=RAMP (default) if the stress unbalance is to be resolved linearly

over the step.

Set UNBALANCED STRESS=STEP if the stress unbalance is to be resolved in the ﬁrst

increment.

Data line to translate an old-model mesh:

First (and only) line:

1. Valueof the translation to be applied in the X-dir ection.

2. Valueof the translation to be applied in the Y-dir ection.

3. Valueof the translation to be applied in the Z-dir ection.

Data lines to translate and/or rotate an old-model mesh:

First line:

1. Valueof the translation to be applied in the X-dir ection.

13.1–1

ABAQUS Version 6.1 Module: ID:

Printed on: