*STEADY STATE TRANSPORT
18.35 *STEADY STATE TRANSPORT: Steady-statetranspor t analysis.
This option is used to indicatethat the step should be analyzed as a steady-state transport analysis.
Product: ABAQUS/Standard
Type: History data
Level: Step
References:
•“Steady-state transport analysis,” Section6.4.1 of the ABAQUS A nalysisUser ’sManual
•“Symmetric model generation,” Section 10.3.1 of the ABAQUS Analysis User’sManual
Optional parameters:
DIRECT
This parameter selects direct user control of the incrementation through the step. If this parameter
is used, constant increments of the size defined by the first item onthe data line are used. If this
parameter is omitted, ABAQUS/Standard will choose the incre ments (after trying the user’s initial
time increment for the first attempt at the first increment).
The parameter can have the value NO STOP. If this value is included, the solution to an
increment is accepted after the maximum number of iterations allowed has been completed (as
defined by the *CONTROLS option), even if the equilibrium tolerances are not satisfied. Very
small increments and a minimum of two iterations are usually necessary if this value is used. This
approach is not recommended; it should be used only in special cases when the analyst has a
thorough understanding of how to interpret results obtained in this way.
ELSET
Set this parameter equal to the name of an element set for which the rigid body motion will be
described in a spatial or Eulerianm anner. The rest of the elements in the model will be treated in a
classical Lagrangian manner. Only one Eulerian element set can be specified in the whole model.
If this parameter is omitted, the rigid body motion in the whole m odel will be described in a
spatial or Eulerian manner.
FACT OR
Set this parameter equal to the damping factor to be used in the automatic damping algorithm
(see “Solving nonlinear problems,” Section 7.1.1 of the AB AQUS Analysis User’s Manual) if the
problem is expected to be unstable due to local instabilities and the damping factor calculated
by ABAQUS is not suitable. This parameter must be used in conjunction with the STABILIZE
18.35–1
ABAQUS Version 6.1 Module: ID:
Printed on: