3D Connexion Version 6.6

*NSET

INTERNAL

ABAQUS/CAE uses the INTERNAL parameter to identify sets that are created internally. The

INTERNAL parameter is used only in models deﬁned in terms of an assembly of part instances.

The default is to omit the INTERNAL parameter.

UNSORTED

If this parameter is included, the nodes in this node set will be assigned to the set ( or added to the

set if it already exists) in the order in which they are given. This parameter will be ignored if the

ELSET parameter is used.

If this parameter is omitted, the nodes in the set are sorte d into ascending order of their node

numbers, with duplicates eliminated.

Data lines if the GENERATE parameter is omitted:

First line:

1. Listof node s or node set labels to be assigned to this node set. Only previously deﬁned node

sets can be assigned to another node set.

Repeat this data line as often as necessary. Up to 16 entries are allowed per line.

Data lines if the GENERATEparameter is included:

First line:

1. First node in the set.

2. Lastnode in the set.

3. Incrementin node numbers between nodes in the set. Thedefault is 1.

Repeat this data line as often as necessary.

There are no data lines when the ELSET parameter is speciﬁed.

14.15–2

ABAQUS Version 6.1 Module: ID:

Printed on: