*POST OUTPUT
16.21 *POST OUTPUT: Postprocess foroutput from the restart file.
Thisopti on can be used only for postprocessing to recover additional printed (.dat), output data base (.odb),
and results file (.fil) output from the restart file of a previous analysis.
Product: ABAQUS/Standard
Type: History data
Level: Model
References:
•“Output,” Section 4.1.1 of the ABAQUS Analysis User ’sManual
•“Restarting an analysis,” Section 9.1.1 of the ABAQUS Analysis User’sManual
Required parameter:
STEP
Set this parameter equal to the step number from which output is required.
Optional parameter:
ITERATION
This parameter applies only to postprocessinga direct cyclic analysis (see “Direct cyclic analysis,”
Section 6.2.6 of the ABAQUS Analysis User’s Manual).
Setthis parameter equal to the iteration number in a direct cyclic analysis from which additional
output is being requested.
Data lines to request output from specified increments ifthe ITERATION is omitted:
First line:
1. Firstinc rement number at which additional output is being requested.
2. Secondincrement number at which additional output is being requested.
3. Etc.,up to eight increments per line.
Repeat this data line as often as necessary to define the increments at which output is required.
To recover additionaloutput from a previous direct cyclic analysis when the ITERATION
parameter is included:
No data lines are needed when the ITERATIONparameter is specified.
16.21–1
ABAQUS Version 6.1 Module: ID:
Printed on: