*SECTION PRINT
averagerigid body motion of the surface section. Thisparameter is relevant only if AXES=LOCAL
and the NLGEOM parameter is active in the step.
Optional data lines:
First line:
1. Nodenumber of the anchor point (blank if coordinates given).
2. Firstc oordinate of the anchor point (ignored if node number given).
3. Second coordinate of the anchor point (ignored if node number given).
4. Thirdcoordinate of the anchor point (for three -dimensional cases only; ignored if node number
given).
Leave this line blank toallow ABAQUS to define the anchor point.
Second line:
1. Nodenumber used to specify point ain Figure 18.5–1 (blank if coordi nates given).
2. First coordinate of point a(ignored if node number given).
3. Secondcoordinate of point a(ignored if node number given).
The remaining data items are relevant only for three-dimensional cases.
4. Third coordinate of point a(ignored if node number given).
5. Nodenumber used to specify point b(blank if coordinates g iven)
6. First coordinate of point b(ignored if node number given).
7. Second coordinate of point b(ignored if node number given).
8. Third coordinate of point b(ignored if node number given).
Leave this line blank to allow ABAQUSto define the axes.
Third line:
1. Give the identifying keys for the variables to be output. The keys are defined in the “ Section
variables” section of “ABAQUS/Standard output variable identifiers,” Section 4.2.1 of the
ABAQUS Analysis User’s Manual.
Omit both the first and second data lines for AXES=GLOBAL or to allowABAQUS to define the anchor
point and the axesfor AXES=LOCAL. Repeat the third data line as often as necessary: eachline defines
a table. If this line is omitted, all appropriate variables (“Output to the data and results files,”Section 4.1.2
of the ABAQUS Analysis User’sManual) will be output.
18.5–2
ABAQUS Version 6.1 Module: ID:
Printed on: