Do not mix print media sizes, weights, or types in the same source. This may result in a paper jam.

Do not remove the PSI while a job is printing.

Ensure that the paper is properly loaded in the MPF or PSI.

Flex paper back and forth, and then fan them. Straighten the edges of the stack on a level surface.

Selecting Preprinted Media and Letterhead

When selecting preprinted media and letterhead paper for the printer:

Use grain long paper for best results.

Use only forms and letterhead printed using an offset lithographic or engraved printing process.

Select paper that absorb ink, but do not bleed.

Avoid paper with rough or heavily textured surfaces.

Use paper printed with heat-resistant inks designed for use in xerographic copiers. The ink must withstand temperatures of 225°C (437°F) without melting or releasing hazardous emissions.

Use inks that are not affected by the resin in toner or the silicone in the fuser. Inks that are oxidation-set or oil-based should meet these requirements; latex inks might not. If you are in doubt, contact your paper supplier.

Printing on Letterhead

Check with the manufacturer or vendor to determine whether the pre-printed letterhead you have selected is acceptable for laser printers.

192

Print Media Guidelines

Page 194
Image 194
Dell 1355cnw, 1355CN manual Selecting Preprinted Media and Letterhead, Printing on Letterhead, 192