Introduction 179
"Configure Network Connections" (page 239)
"Configure card properties" (page 240)
"Configure DSP profiles for the IP Trunk 3.01 (and later) node" (page 244)
"Configure SNMP Traps/Routing and IP addresses tab" (page 247)
"Configure Accounting server" (page 250)
"Control node access with SNMP community name strings" (page 251)
"Exit node property configuration session" (page 252)
"Createthe IPTrunk 3.01(and later) node dialing plan using TM 3.1" (page 253)
"Retrieve the IP Trunk 3.01 (and later) node dialing plan using TM 3.1" (page
258)
"Transmit IP trunk card configuration data from TM 3.1 to the IP trunk cards"
(page 260)
"Before configuration data is transmitted" (page 260)
"Configure the Leader 0 IP address" (page 260)
"Backup Leader installation for IP Trunk 3.01 (and later)" (page 262)
"Transmit the node properties, card properties and dialing plan to Leader 0"
(page 264)
"Verify installation and configuration" (page 266)
"Observe IP Trunk 3.01 (and later) status in TM 3.1" (page 266)
"Transmit card properties and dialing plan to Leader 1 and Follower cards"
(page 268)
"Configure date and time for the IP Trunk 3.01 (and later) node" (page 269)
"Change the default ITG shell password to maintain access security" (page 270)
"Change default ESN5 prefix for non-ESN5 IP telephony gateways" (page 271)
"Check and download IP trunk card software in TM 3.1" (page 272)
"Transmit new software to the IP trunk cards" (page 274)
"Upgrade the DCHIP PC Card" (page 276)
"Configure TM 3.1 Alarm Management to receive SNMP traps from the IP trunk
cards" (page 277)
"Make test calls to the remote nodes (ITG Trunk or IP Trunk)" (page 280)
IntroductionThis chapter describes how to add a new IP Trunk 3.01 (and later) trunk

node in TM 3.1, how to install the IP trunk cards and cables, and how to

configure and transmit the node properties.

Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.