Change default ESN5 prefix for non-ESN5 IP telephony gateways 271
Enter new password again to confirm: new password
5Record the new user name and passwordand transmit to authorized
network security personnel.
6Repeat procedure for all cards in the node.
—End—
If the entire sequence of commands is successfully entered, the system
response value = 0 = 0x0 is displayed. The new user name and
password are now stored in the non-volatile RAM on the IP trunk card and
are retained even if the card is reset, powered-off, or on.
Toreset the ITG shell password to its default setting, see "Reset the default
ITG shell password" (page 372).
Change default ESN5 prefix for non-ESN5 IP telephony gateways
Follow the steps in Procedure 34 "Changing the default ESN5 prefix for
non-ESN5 IP telephony gateways"(page 271) to configure an ESN5 prefix
for the non-ESN5 IP telephony gatewaysby using the "esn5PrefixSet"
command from the ITG shell CLI. The default esn5 prefix (100) corresponds
to NCOS 00. If NCOS 00 does not allow access to all the required trunk
facilities, change the defaultESN5 prefix to work with the established NCOS
plan in the customer’s network. Refer to "ESN5 network signaling" (page
231). Perform this procedure on every card in the node.
Procedure 34
Changing the default ESN5 prefix for non-ESN5 IP telephony gateways
Step Action
1Select the new IP Trunk3.01 (and later) node in the upper par t of
the IP TelephonyGateway - ISDN IP Trunk window.
2For each IP trunk card in the node, right-click the IP trunk card and
select Telnet to ITG Card from the right-click menu.
The Telnet windowappears with the VxWorks prompt.
3When prompted to login, enter the default (or user-modified) login
and password.
VxWorks login: itgadmin
Password: itgadmin
ITG> esn5PrefixShow
See Figure 62 "esn5PrefixShow" (page 272).
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21December 2007
Copyright© 2007, Nor tel Networks
.