Nortel Networks NN43001-563 - page 229

Configure IP Trunk3.01 (and later) data 229
Prompt Response Description
For nodes containing a mixture of 24-port and 32-port IP
trunk cards, determine the starting CHID by adding the
number of channels (ports) on the previous card to the
CHID of the previous card.
Example:
Leader 0: - 1 (24-port card)
Leader 1: - 25 (1 + 24) (32-port card)
Follower: - 57 (25 + 32) (32-port card)
The same First CHID must be entered in TM 3.1 (and later)
ITG ISDN IP Trunk Node Properties, Card Configuration,
"First CHID" field for this card. If this is not done, the trunk
unit seized by the core switch doesnot match the trunk unit
seized on the IP trunk card and the calls fall.
The standard First CHID matches the trunk route
member number for the trunk unit 0 in order to facilitate
administration and maintenance.
...
STRI WNK Start Arrangement Incoming.
Wink Start is preferred for IP Trunk 3.01 (and later).
STRO WNK Start Arrangement Outgoing.
Wink Start is preferred for IP Trunk 3.01 (and later).
SUPN YES Answer supervision is required.
CLS (NHFD)/NHFA (Deny)/Allow the Trunk Hook Flash feature over 911P
trunks.
DIP Dial Pulse is required for IP Trunk 3.01 (and later) to avoid
busying multiple Digitone receivers when IP trunk card
faults occur.
Trunks must always be set to DIP. If SIG0 = ESN5 in the
RDB, the
Meridian 1/CS 1000M does not allow CLS = DIP in LD 14.
To avoid this problem and retain ESN5 signaling, set SIG0
= STD in RDB (LD 16). Then provision CLS = DIP in LD 14
for IP Trunk 3.01 (and later). After all trunks have been
programmed, in LD 16 change the RDB back to SIG0 =
ESN5.
...
Use the "NEW XX" command to assign DES equal to the IP trunk card
ELAN network interface IP address; for example: 10.1.1.1. For unit 0, use
CHG command to assign DES equal to the IP trunk card ELAN network
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.