Contents 7
Jitter buffer parameters (voiceplayout delay) 162
Silence Suppression parameters (VoiceActivity Detection) 163
Fallback threshold 164
Setting the QoS threshold for fallback routing 164
Post-installation network measurements 164
Set ITG QoS objectives 165
Intranet QoS monitoring 166
SNMP network management 167
IP Trunk3.01 (and later) network inventory and configuration 167
User feedback 168
TM 3.1 management and configuration of IP Trunk 3.01 (andlater) 169
Contents 169
Introduction 169
TM 3.1 ITG Engineering rules 169
TM 3.1 network setup guidelines 170
TM 3.1 remote access configuration 170
TM 3.1 PC description 172
TM 3.1 PC hardware and software requirements 173
Hard drive requirements 174
Install and configure IP Trunk 3.01 (and later) node 177
Contents 177
Introduction 179
Before you begin 180
Installation procedure summary 180
ESN installation summary 182
Create the IP Trunk3.01 (and later) Installation Summary Sheet 183
Channel Identifier planning 184
Preferred ISL channel numbering 184
Incorrect ISL channel numbering plans 189
Install and cable IP Trunk3.01 (and later) cards 190
Card installation procedure 190
Install NTCW84JA Large System I/O Panel 50-Pin filter adapter 193
Remove existingI/O panel filter adapter 194
Install NTMF94EA and NTCW84KA cables 195
Install the NTCW84KA cable (for DCHIP cards) 196
Install the NTMF94EA cable (for non-DCHIP cards) 197
Install shielded TLAN network interface cable 198
Install shielded ELAN network interface cable 199
D-channel cabling forthe NT0961AA ITG-Pentium24-Port trunk card 199
Required cables and filters for Large Systems 199
Configure NT6D80 MSDL switches 199
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.