Nortel Networks NN43001-563 Retrieve the IP Trunk3.01 (and later) node dialing plan using TM 3.1

258 Install and configure IP Trunk3.01 (and later) node
6Click Apply.
7Repeat steps 7 through 11 until all the ESN translation Dial Plan
digits for this destination node have been added.
8Click OK.
The Dialing Plan window appears with the added dialing plan
entries.
9Repeat steps 2 through 13 until dialing plan entries for all the
destination nodes in the drop down list and all destination nodes Not
Defined on this TM 3.1 PC have been added.
—End—
Retrieve the IP Trunk3.01 (and later) node dialing plan using TM 3.1
If adding a new node to a large existing network, it is more efficient to
retrieve the IP Trunk3.01 (and later) node dialing plan from an existing
node. Make the necessary modifications before transmitting the dialing plan
to the new node. Follow the steps in Procedure 26 "Retrieving the IP Trunk
3.01 (and later) node dialing plan using TM 3.1" (page 258) to retrieve the
IP Trunk3.01 (and later) node dialing plan.
ATTENTION
Important
When TM 3.1 is launched, it launches its own FTP service. Other FTP ser vices,
such as those found in WindowsNT4 and Windows 2000 (which are launched by
default) must betur ned off,or TM 3.1 will not work proper ly.
Procedure 26
Retrieving the IP Trunk3.01 (and later) node dialing plan using TM3.1
Step Action
1In the IP TelephonyGateway – ISDN IP Trunk window, select an
existing IP Trunk3.01 (and later) node which has a dialing plan
similar to one to be created for the new IP Trunk 3.01 (and later)
node.
2Ensure that TM 3.1 can monitor the card state of Leader 0 in the
existing node from which the dialing plan is being retrieved. Record
the Management IP address of Leader 0 on the existing node.
3Select the new node and double-click to open its Node Properties
sheet.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.