Configure IP Trunk3.01 (and later) data in TM 3.1 239
For traffic reasons, use separate subnets for nodes consisting of multiple
ITG-Pentium 24-port trunk cards and Media Card 32-port trunk cards.
Refer to the Engineering Guidelines sections "Configure a system with
separate subnets for voice and management" (page 153) and "Single
subnet option for voice and management" (page 156).
If the single subnet option is selected, the ELAN subnet is used for the
voice and management network and all voice and managementdata goes
through the 10BaseT ELAN network interface (lnIsa0) on the motherboard
of the IP trunk card.
Configure Network Connections
Follow the steps in Procedure 18 "Configuring network connections" (page
239) to configure the network connections.
Procedure 18
Configuring network connections
Step Action
1Decide subnet settings:
a. If using separate subnets for the voice (TLAN subnet) and
management (ELAN subnet) networks, accept the default setting
Use separate subnets for voice and management check box.
b. If using the same subnet for the voice and management network
(ELAN subnet), uncheck the Use separate subnets for voice
and management check box. The window changes.
2If using the defaultsetting Use separate subnets, perform steps a-d.
a. Enter the TLAN node IP address in the Voice LAN Node IP
address field.
b. Enter the ELAN network interface gateway IP address in the
Management LAN gateway IP address field.
c. Enter the ELAN network interface subnet mask in the
Management LAN subnet mask field.
d. Enter the TLAN network interface subnet mask in the Voice LAN
subnet mask fields
The VoiceLAN Node IP address on the General tab and the
VoiceIP and Voice LAN gateway IP addresses for Leader 0
and Leader 1 on the Card Configuration tab must be on the
same subnet.
3If Use separate subnets was unchecked, perform steps a-c as
follows.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.