266 Install and configure IP Trunk3.01 (and later) node
Verify installation and configuration
Toverify installation and configuration, check the IP trunk card faceplate
displays.
After successfully rebooting, the Leader 0 card is now fully configured with
the Node Properties of the node and enters a state of "Active Leader". The
faceplate display shows "LDR".
The Leader 1 card is nowautoconfigured as a Leader,reboots automatically,
and enters the state of "Backup Leader". The faceplate display shows
"BLDR".
Any Follower cards are now auto-configured with their IP addresses and
their display shows "FLR".
If an TM 3.1 PC is on the local ELAN subnet, it should now be in
communication with all cards in the IP Trunk3.01 (and later) node.
Observe IP Trunk 3.01 (and later) status in TM 3.1
Follow the steps in Procedure 30 "Observing the IP Trunk 3.01 (and later)
status in TM 3.1" (page 266) to observe the IP Trunk 3.01 (and later) status
in TM 3.1.
Procedure 30
Observing the IP Trunk3.01 (and later) status in TM 3.1
Step Action
1From the TM 3.1 IP TelephonyGateway - ISDN IP Trunk window,
select menu View > Refresh and verify that the card status is
showing "enabled" or "disabled", depending on the card status in the
system. See Figure 61 "IP trunk card status" (page 267).Ifany
cards show "not responding", verify the following:
a. the ELAN network interfacecable connection to the ELAN subnet
b. the TLAN network interface cableconnection to the TLAN subnet
c. the ELAN MAC addresses that were entered previously on the
Configuration tab of the Node Properties, while adding the IP
Trunk3.01 (and later) node on TM 3.1
d. IP addresses
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.