Configure TM 3.1 Alarm Management to receive SNMP traps from the IP trunk cards 277
VxWorks login: itgadmin
Password: itgadmin
ITG>
4Disable the ITG-Pentium24-por t or Media Card 32-port trunk card in
LD 32 (DISI lsc). Wait for the NPRxx message.
5Use the command DCHdisable to disable the D-channel function
on the card.
6Use the command loader 1, "/C:pcmv32.bin" to transferthe
DCHIP PC Card software to the DCHIP PC Card.
The ’1’ indicates the internal PC Card slot on the DCHIP Card. For
the external PC Card Slot, use ’0’.
The DCHIP card checks whether or not it is a Leader card.
The DCHIP PC Card software is downloaded to the Leader card
first.
If it is a Leader card, it copies the DCHIP PC Card software from its
own /C: drive. If it is not a Leader card, it FTPs the DCHIP PC Card
from the Active Leader card. Since the FTP server on the IP trunk
card is password protected, enter the login and passwordwhen
prompted. If correct, the upgrade of the DCHIP PC Card begins.
—End—
Once the upgrade is complete, the DCHIP card reboots automatically.
Configure TM 3.1 Alarm Management to receive SNMP traps fromthe IP trunk cards
Follow the steps in Procedure 38 "Configuring TM 3.1 ALarm Management
to receive SNMP traps from the IP trunk cards" (page 278) to configure TM
3.1 Alarm Management to receive SNMP traps from the IP trunk cards.
The TM 3.1 Alarm Management option must be enabled to perform this
procedure. For the procedure to activate SNMP trap generation on the
IP Trunk3.01 (and later) node, see "Configure SNMP Traps/Routing and
IP addresses tab" (page 247). Enter the IP address of the TM 3.1 PC as
described in that procedure.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.