Access the ITG shell through a maintenance port or Telnet 369
Access the ITG shell from the TM 3.1 PC. Refer to "Telnetto an IP trunk
card through the TM 3.1 PC" (page 370) for details.
Connect a PC to the card maintenance port
Follow the steps in Procedure 60 "Connecting a PC to the IP trunk card
maintenance port" (page 369) to connect a PC to the IP trunk card
maintenance port.
Procedure 60
Connecting a PC to the IP trunk card maintenance port
Step Action
1Toaccess the ITG shell, connect a PC to the RS-232 serial
maintenance port through DIN-8 connector on the faceplate of the
ITG Leader 0 card with an NTAG81CAPC Maintenance cable. If
required, use an NTAG81BAMaintenance Extender cable to provide
an extension between the NTAG81CAPC Maintenance cable and
the TM 3.1 PC.
Alternatively, forthe ITG-Pentium 24-port trunk card, connect
the NTAG81BAMaintenance Extender cable to the female DB-9
connector of the NTCW84KA ELAN, TLAN, DCH, and Maintenance
Port cable (for DCHIP cards), or the NTMF94EA ELAN, TLAN,
Maintenance Port cable (for non-DCHIP cards), to create a more
permanent connection to the IP trunk card serial maintenance port.
For the Media Card 32-port trunk card, a serial connection can be
established by using the DB-9 connector located on the "L-Adaptor"
A0852632.
Neverconnect two terminals to the front and back serial maintenance
port connectors at the same time.
2Use the following communication parameters forthe TTY ter minal
emulation on the PC:
9600 baud
8 bits
no parity bit
one stop bit
3When prompted to login, enter current username and password.
Default is:
VxWorks login: itgadmin
Password: itgadmin
ITG>
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21December 2007
Copyright© 2007, Nor tel Networks
.