Configure IP Trunk3.01 (and later) data in TM 3.1 241
When adding the first card, select the card role Leader 0. When
adding the second card, select the card type Leader 1. When
adding additional cards, select the card type Follower. Configure
the DCHIP and D-Channel information.
3If Use separate subnets in the General tab was checked earlier,
perform steps a-d.
a. Enter the Management IP address (ELAN network interface IP
address).
b. Enter the Management MAC address (ELAN network interface
MAC address). It is the motherboard Ethernet address. Findit
on the faceplate label of the card currently being configured. It is
also identified as lnIsa0 on the card startup messages and by
the ifShow command in the ITG shell.
c. Enter the VoiceIP address (TLAN network interface IP address).
See Notes 1 and 2.
d. Enter the Voice LAN gatewayIP address. (TLAN network
interface gatewayIP address), See Notes 1 and 2.
Figure 52
Configuration tab
The TLAN Node IP address on the General tab and the TLAN
network interface IP address and TLAN network interfacegateway
IP addresses for Leader 0 and Leader 1 on the Card Configuration
tab must be on the same TLAN subnet.
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.