Configure IP Trunk3.01 (and later) data 223
Prompt Response Description
- PNI (0) – 32700 Private Network Identifier. Configure the PNI to 1 or other
non-zero value to support Meridian Customer Defined
Network (MCDN) features that use non-call-associated
signaling, such as Network Ring Again (NRAG) Network
Message Services (NMS), Network ACD (NACD). Each
feature needs ISDN signaling to be sent across the
Meridian 1/CS 1000M network in the absence of a call.
The PNI in the Customer Data Block must be the same
as the PNI configured in the Route Data Block at the far
end for outgoing calls from the far end toward this Meridian
1/CS 1000M node.
... ... ...
Configure IP Trunk 3.01 (and later) TIE trunk routes
For Release 5.0 Horizon, a new trunk sub-type is introduced, the Route
Data Block, exclusively forTIE tr unks. All the prompts specific to 911 in
the RDB are made applicable when the TKTP prompt value is TIE. In
the case of TIE trunks, the M911_TRK_TYPE prompt does not appear
and is replaced by the newly introduced M911P prompt. The M911_ANI,
M911_NPID_FORM, and NPID_TBL_NUM are not prompted. Use LD 16 to
configure the IP Trunk3.01 (and later) TIE trunk routes.
If M911P prompt is set to YES:
•a new prompt ABTR is prompted. This prompt has a default value of
15 minutes.
•the DTRK prompt is set to YES and is non-configurable.
•the IFC prompt is set to SL1 and is non-configurable.
Trunkroutes must be configured as TIE routes.
LD 16 Configure the IPTrunk 3.01 (and later) TIE Trunk Route Data Block
Prompt Response Description
REQ NEW Add new data.
TYPE RDB Route Data Block. Configuration parameters that apply to
all trunks in this route.
CUST xx Customer number as defined in LD 15.
ROUTE xxx Route number, where:
x = 0 – 511
DES IP TRUNK 16-character designator is IP TRUNK. Specific description
if more than one IP Trunk 3.01 (and later) route exists.
...
Nortel Communication Server 1000
IP TrunkFundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright© 2007, Nor tel Networks
.